Kent Nguyen's Lab #indatawetrust
TES Hub 3D Sand Battery Explainer TES Competitor Matrix Next Cold Storage & PCM Planned
Open Engineering Knowledge Base

Thermal Energy Storage (TES): Materials, 3D Architecture & Market Map

Roughly half of global final energy demand is heat or cooling, not electricity. Storing cheap off-peak or renewable power directly as heat (in sand, bricks, carbon, or rock) or as cold (in phase-change materials) skips the cost and degradation of electrochemical cells. This hub documents the real physics, hardware cutaways, and competitive landscape across the TES industry.

Live Interactive 3D

3D Sand Battery Explainer

Orbit, slice, and explode a 250 kWh sand battery based on real engineering geometry and US 12,130,086 B1 / WO2025038037A1 physics. Test pure sand vs sand-graphite and active vs bypassed thermal isolation valves.

Launch 3D Explainer →
Next Cycle

Global TES Competitor Matrix

Side-by-side engineering database comparing Antora Energy, Rondo Energy, Exowatt, Polar Night Energy, Brenmiller, Kraftblock, Fourth Power, and Electrified Thermal Solutions by medium, temperature band, and discharge output.

In preparation
Planned

Cold Storage & PCM Batteries

Sub-zero and medium-temperature phase-change thermal storage for cold-chain logistics, seafood transport, and domestic hot water, including VOX Cool (Vietnam) and Sunamp (Plentigrade PCM).

Planned expansion

Why Thermal Storage Matters Right Now

Solar and wind generation are already cheap, but their output peaks at midday or overnight when factories are idle or grids curtail power. Electrochemical lithium-ion packs excel at fast grid frequency response and electric vehicles, yet using them to run industrial dryers, boilers, or cold-chain reefers adds unnecessary conversion steps and cell wear.

Thermal batteries take a simpler route: turn cheap electrons into heat (or cold) right away, park that thermal energy in an abundant medium like quartz sand, refractory brick, carbon blocks, or salt-hydrate PCM, and dispatch it on demand across hours or days.

Start with the Interactive 3D Sand Battery Explainer to inspect every physical layer of a 600°C solid-state sand unit from the inside out.